Multi-stage polishing kit. Contains abrasive and polishing stages.  The number of stages needed depends on the surface condition of the metal.

For the abrasive process, the kit contains Satene (abrasive compound) its a glue and abrasive mix that is coated on the wheel and left to dry for several hours.

Instructions

Rigger Gloves

FFP1 Dust Mask- Better quality dust mask.

Vienna Lime Powder- Cleaning

1 off Standard Taper for 4" Mops

1 off Long taper 2" and smaller mops

6 off felts 1/4"x1/2"(6mm x 12mm)

6 off felts 3/8"x1/2"(10mm x 12mm)

6 off felts1/2"x1" (12mm x 25mm)

Felt can be used for abrasive and polishing work, Ideal for very awkward areas.

For Polishing Work:

1 off 4"x1" G loose mop (100mm x 25mm)

1 off 4"x1" white mop close stitch (100mm x 25mm)

1 off 4"x1" sisal mop (100mm x 25mm)

600 Gram Bar P164 Menzerna Polishing Compound General finishing compound

600 Gram Bar 439T Menzerna Polishing Compound Medium cutting & colouring compound

600 Gram Bar 523LBZ Menzerna Polishing Compound Grey heavy cutting compound

For Abrasive Work:

3 off 4"x1" section colour mops (100mm x 25mm)

Selection of colour stitch mops.

1 off 450gram 80grit abrasive compound

1 off 450gram 150grit abrasive compound

1 off 450gram 300grit abrasive compound

Quick rundown of the kit, basically two parts. On the abrasive side where we focus on removing heavy marks and scratches and get to the 300 grit finish. From the 300 grit, we can them work through three polishing processes for a bright mirror finish. Important you do not have to use all the processes in the kit, it will depend on the condition.

The abrasive compound is an old method for abrasive work, it is a glue/abrasive mix that can be melted onto a polishing wheel then left to dry (can take several hours). I would say yes it takes some time to coat and dry but it is a very flexible abrasive method. It can be coated on the blue denim mops and on the smaller felt wheels. I would advise especially when coating small items to take a small quantity of abrasive compound inside a sealed plastic bag which can then be dropped into hot water, this will melt the glue making it easier to apply.